Research area and keywords of research:
Research the drilling of the industrial plastic parts in cryogenic environment
Name of the research group:
- Dr. Ravai Nagy Sándor
- Dr. Szigeti Ferenc
- Százvai Attila
- Dr. Varga Gyula (ME)
Name of the Institute:
University of Nyíregyháza, Institute of Engineering and Agricultural Sciences
Research objectives:
Study the cryogen environment effects on the drilled hole accuracy, the hole roughness and on the chip removing mechanism.
Description and results of research:
The chips in the cold environment (-35 ° C) did not lint, if are set the right cutting parameters the chip does not twist on the tool. The clearance of the hole diameter machined in a cryogenic environment is significantly smaller than on room temperature. In the case of cryogenic cooling, most roughness parameter combinations measured smaller surface roughness values. The roughness of the machined surface is smaller when are machined whit cryogen cooling.
Publications: 5 conference presentations (+ proceedings), 2 scientific articles
Research partners from other institutions:
- University of Miskolc
- Technical University of Cluj-Napoca - North University Center of Baia Mare
Other information: -
Publications (max. 5):
- Sándor, Ravai Nagy; Mircea, Lobonțiu ; Nicolae, Medan ; Ferenc, Szigeti: Experimental studies on drilling in cryogenic conditions the industrial plastic parts. In: Ripanu, MI; Kyratsis, P; Merticaru, V; Nagit, G; Ibanescu, R; Boca, M; Dodun, O; Coteata, M; Panait, CE; Slatineanu, L; Mihalache, AM; Oancea, G (szerk.) 21st Innovative Manufacturing Engineering and Energy International Conference, IManE and E. EDP Sciences, (2017) Paper: 10.1051/matecconf/201711201024
- Sándor, Ravai Nagy; Medan N., Szigeti F.: Aspects of Design of Experiments on Machining Technology by Forming the Internal Threads. In: N, Balc (szerk.) Modern Technologies in Manufacturing: MTeM 2017–AMaTUC, Cluj-Napoca, Románia: Trans Tech Publications, (2017). Paper: https://www.matec-conferences.org/articles/matecconf/pdf/2017/51/matecc… , 6 p.
- Varga G, Ravai-Nagy S, Szigeti F (2018): Examination of surface roughness of holes of plastic parts drilled under cryogenic cooling conditions. IOP Conf Ser Mater Sci Eng 448:012065. ISSN: 1757-899X. https://doi.org/10.1088/1757-899X/448/1/012065